Search

You can find the results of your search below.

Fulltext results:

Router Hardware
4 Hits, Last modified:
ts: 2 x Marvell AQC113C-B1-C 10Gbps Network cards(via PCIe 3.0 x 2), 2 x Intel i226-v 2.5G network cards (via PCIe 3.0 x 1) *AQC113C-B1-C is a 6-Speed Com... speed. (At the moment my internet connection is via fibre and is limited to about 1000Mb/s down and u... ll. Up until March 2024 my internet connection is via VSDL and is limited to about 65Mb/s down and 16MB
Wireguard VPN access from WAN to LAN
3 Hits, Last modified:
h attempts. As I only allow ssh locally on LAN or via VPN I drop all such incoming traffic. (Also proba... 03 21:25:44 Router systemd[1]: Starting WireGuard via wg-quick(8) for wg0... Jul 03 21:25:44 Router wg-... 03 21:25:44 Router systemd[1]: Started WireGuard via wg-quick(8) for wg0.</code> then\\ ''sudo ip a sh
DHCP / DNS Setup
3 Hits, Last modified:
ome server applications now are set up to operate via https via Traefik and this also relies upon correct local D... on the internal network to be reached externally via NAT also to be reached by internal clients behind
NFTables Configuration
2 Hits, Last modified:
h attempts. As I only allow ssh locally on LAN or via VPN I drop all such incoming traffic. (Also proba... rsion of nft I have will not read in the elements via a nft -f command.) Some info on NAT with NFTable
Router Configuration, Switch & Server Setup
2 Hits, Last modified:
TUN/TURN services. - I have tried to use IPv6 via a HE tunnel arrangement, but felt this was not wo... vice is available. * If accessing the equipment via a web browser, open a new page and ensure that th
TC - Traffic Control
2 Hits, Last modified:
package installs the tc command to control these via the command line.\\ Queuing controls how data is ... ash nat ack-filter-aggressive # Download shaping via IFB ExecStart=/sbin/ip link add ifb-wan0 type ifb
Wifi Router / Access Points
2 Hits, Last modified:
large,single level, so I run 2 wifi APs connected via Ethernet for better overall coverage. The AP Eth... use of 2 wireless access points connect upstream via Ethernet, which gives better wifi radio coverage
Router VM
1 Hits, Last modified:
net ports) * Access to public internet modem, via 1 Ethernet port - **the WAN (Wide Area Network) c
ISP PPPoE Network Setup
1 Hits, Last modified:
o1 ExecStartPre=/sbin/ip route add 192.168.5.0/24 via 192.168.5.1 dev eno1 </code> <fs smaller>A refer
ISP IPoE DHCP Setup Notes
1 Hits, Last modified:
202.7.254.238 (DHCP4 via 202.7.254.1) fe80
Router Miscellaneous
1 Hits, Last modified:
ect the LANs to the WAN (Wide/World Area Network) via a router. This was required to compensate for the