Search
You can find the results of your search below.
Matching pagenames:
Fulltext results:
- Debian Server Network Setup
- ded: ''sudo apt install bridge-utils''. Edit the network configuration file: ''/etc/network/interfaces'' as follows: ++++/etc/network/interfa... a is not used here. ++++ It is important that the network/interfaces method is disable or strange difficult to diagnose network affect may happen. Basically ensure that all item... am using Debian 12 now and am moving back to /etc/network/interfaces for network configuration. As the DHCP and DNS server now ru... /etc/netplan/50-cloud-init.yaml #mv /etc/netplan/network.yaml /etc/netplan/network.yaml.old ln -sf /etc/nftables.conf.orig /etc/nfta
- Router Miscellaneous
- [https://www.tecmint.com/darkstat-web-based-linux-network-traffic-analyzer/|Darkstat – A Web Based Linux Network Traffic Analyser]], is a relatively low resource ... se special addresses for private LANs (Local Area Network)s with NAT (Network Address Translation) used to connect the LANs to ... interface-ubuntu-linux/|How To Setup Bridge (br0) Network]], & [[https://www.cyberciti.biz/faq/debian-network-interfaces-bridge-eth0-eth1-eth2/|Debian Linux: Configure Network Interfaces As A Bridge / Network Switch]] *Unixmen Ubuntu [[https://www.unixmen.
- NFTables Configuration
- [https://wiki.kptree.net/doku.php?id=linux_router:network#ubuntu_network_-_interface_setup|network interface]].</color>++\\ <tab3>define <color red... [https://wiki.kptree.net/doku.php?id=linux_router:network#ubuntu_network_-_interface_setup|network interface]].</color>++\\ <tab3>define <color red... oopback-to-forwarded-public-ip-address-from-local-network-hairpin-nat|Loopback to forwarded Public IP address from local network - Hairpin NAT]] The following commands provide a... or IPv6, hence unless NAT is used in a IPv6 local network hairpin. * Whilst investigating this matter's co
- Router Configuration, Switch & Server Setup
- n IP address to interface eth0 Once the computer network has been manually assigned and network reset check that the network address and mask have been correctly set. If the assigned network mask is incorrect, that is in most cases not /24 ... <- linux_router:hardware|Prev page ^ linux_router:start|Start page ^ linux_router:network|Next page ->
- Router VM
- s not fully suitable for purpose. * A bridge network setup on the remaining 3 Ethernet ports as a LAN (Local Area Network). The bridge network setup has the following required features: * It allows connections of multiple ... e device, with the bridge effectively acting as a network switch for the connected physical ports. (On my ... ll these physical ports are connected to a common network bridge device. This seem to just work, and each p
- Router Hardware
- *Ethernet Ports: 2 x Marvell AQC113C-B1-C 10Gbps Network cards(via PCIe 3.0 x 2), 2 x Intel i226-v 2.5G network cards (via PCIe 3.0 x 1) *AQC113C-B1-C is a 6-Speed Commercial Temperature Grade, RoHS 6/6* network chipset *Storage: 2 x M.2 2242/2280 NVMe SSD, P... CP for DHCP * Wireguard for remote access to my network I would consider to try setting up a VM and Docke... N Port, allowing full remote KVM operation on the network. A downside of the IPMI is that it uses another 3
- TC - Traffic Control
- ====TC - Traffic Control====== The Linux kernel's network stack has network traffic control and shaping features. The iproute... ; receiving data is much more reactive with fewer network-oriented controls. However, since TCP/IP packets ... it would seem that Linux has default settings for network interfaces, e.g.: <code>qdisc mq 0: root qdisc f... ame ping spikes to 300ms whenever someone on your network starts a large download. When a router’s outgoing
- IPTables Configuration
- ange the file permissions: ''sudo chown root /etc/network/if-pre-up.d/iptables'', and ''sudo chmod 755 /etc/network/if-pre-up.d/iptable''. Note that if /etc/network/if-pre-up.d/iptables is not complete the network may not start-up. This is desirable, as router connectiv
- Basic Netfilter Function Block Diagram
- T Table=== The ''nat'' table is used to implement network address translation rules. As packets enter the network stack, rules in this table will determine whether... her lengthening or shortening the number of valid network hops the packet can sustain. Other IP headers can... ually applied very soon after the packet hits the network interface. The ''raw'' table has a very narrowly
- ISP IPoE DHCP Setup Notes
- systemd/network/99-default.link Network File: /run/systemd/network/10-netplan-eno1.network Type: ether ... tion Model: I210 Gigabit Network Connection HW Address: 0c:c4:
- Wireguard VPN access from WAN to LAN
- [https://wiki.kptree.net/doku.php?id=linux_router:network#ubuntu_network_-_interface_setup|network interface]].</color>++\\ <tab3>define <color red... + \\ <tab9><color blue> # bad tcp -> avoid network scanning: </color>\\ <tab9> tcp flags & (f
- DHCP / DNS Setup
- nity/tutorials/how-to-configure-bind-as-a-private-network-dns-server-on-debian-9|How To Configure BIND as a Private Network DNS Server on Debian 9]]\\ *[[https://computing... allow services provided by hosts on the internal network to be reached externally via NAT also to be reach... et declaration in your dhcpd.conf file for the network segment to which interface eno4 is attached. *... daemon for IPv6 Documentation=man:radvd(8) After=network.target ConditionPathExists=/etc/radvd.conf [Serv
- ISP PPPoE Network Setup
- er pppoe pppoed ISP mtu dns dhcp}} =====ISP PPPoE Network Setup===== A reasonably comprehensive discussion... n mynetfone". If successful there should be a new network interface ppp1 <fs smaller>Some useful links: Ub... rward=1'' To see all system variables concerning network: ''sysctl -a | grep net'' <- linux_router:network|Prev page ^ linux_router:start|Start page ^ linux_rout
- Wifi Router / Access Points
- i/uhttpd.lua' option script_timeout '60' option network_timeout '30' option http_keepalive '20' option ... rt]] *[[https://openwrt.org/docs/guide-user/network/wifi/wifiextenders/bridgedap|Wi-Fi Extender/Repea... et]] *[[https://openwrt.org/docs/guide-user/network/wifi/routedap|Routed AP]] *[[https://openwr
- NFTables IP Control
- chain tcp_cek { # bad tcp -> avoid network scanning: tcp flags & (fin|syn) == (fin