Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
personal:sprinkler [2022-12-06 Tue wk49 11:45] – [Pop-ups] baumkp | personal:sprinkler [2023-04-30 Sun wk17 17:43] – external edit 127.0.0.1 | ||
---|---|---|---|
Line 9: | Line 9: | ||
*The previous owner(s) had placed trees close to or on top of the various valves. To make matters worse some of the plant were inappropriate for an urban block, e.g. large ficus trees. I had the ficus trees removed. | *The previous owner(s) had placed trees close to or on top of the various valves. To make matters worse some of the plant were inappropriate for an urban block, e.g. large ficus trees. I had the ficus trees removed. | ||
*The previous owner(s) had already modified and repaired the piping and control valve wiring to allow for the overgrown plants and trees. | *The previous owner(s) had already modified and repaired the piping and control valve wiring to allow for the overgrown plants and trees. | ||
- | *The control valve wiring only used old fashion car crimp fittings. | + | *The control valve wiring only used old fashion car crimp fittings. |
Changes I made over the past 10 years or so: | Changes I made over the past 10 years or so: | ||
Line 50: | Line 50: | ||
|60°||Very uncommon| | |60°||Very uncommon| | ||
|150°||Very uncommon| | |150°||Very uncommon| | ||
- | The angle and radius configuration can vary vary. | + | The angle and radius |
====Brush Heads==== | ====Brush Heads==== | ||
Line 57: | Line 57: | ||
I generally use the Pope 90° (60Lph @ 150kPa), 180° (80Lph @ 150kPa) and 360° (110Lph @ 150kPa) spray jet nozzles. | I generally use the Pope 90° (60Lph @ 150kPa), 180° (80Lph @ 150kPa) and 360° (110Lph @ 150kPa) spray jet nozzles. | ||
If I want higher flow rate from these nozzles I have on occasion drilled our the ports to 1.5mm or 2mm diameter. | If I want higher flow rate from these nozzles I have on occasion drilled our the ports to 1.5mm or 2mm diameter. | ||
+ | |||
+ |