Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| linux_router:network [2023-07-04 Tue wk27 19:38] – [Router Configuration Network Setup] baumkp | linux_router:network [2023-07-08 Sat wk27 10:13] (current) – [Debian / Ubuntu Network - Interface Setup] baumkp | ||
|---|---|---|---|
| Line 19: | Line 19: | ||
| # This file describes the network interfaces available on your system | # This file describes the network interfaces available on your system | ||
| # and how to activate them. For more information, | # and how to activate them. For more information, | ||
| - | | + | |
| + | | ||
| + | | ||
| # The loopback network interface | # The loopback network interface | ||
| auto lo | auto lo | ||
| Line 25: | Line 27: | ||
| # The WAN network interface | # The WAN network interface | ||
| - | auto eno1 | + | auto eno1 eno1:0 |
| - | iface eno1 inet static | + | iface eno1 inet dhcp |
| - | # set up ip address to access modem web page on WAN NIC | + | # dhcp for IP/DHCP WAN (static? for PPPOE) |
| + | # set up static | ||
| + | iface eno1:0 inet static | ||
| address 192.168.5.2/ | address 192.168.5.2/ | ||
| - | # broadcast 192.168.5.255 #is this require any more? | ||
| # Then LAN networks are eno2 eno3 eno4 in bridged mode br1 | # Then LAN networks are eno2 eno3 eno4 in bridged mode br1 | ||
| # on the 192.168.1.1 subnet | # on the 192.168.1.1 subnet | ||
| - | auto br1 | + | auto br0 |
| - | iface br1 inet static | + | iface br0 inet static |
| bridge_ports eno2 eno3 eno4 | bridge_ports eno2 eno3 eno4 | ||
| address 192.168.1.1/ | address 192.168.1.1/ | ||
| - | | + | |
| - | #netmask 255.255.255.0 #is this require any more? | + | |
| - | # | + | |
| - | dns-nameservers 192.168.1.1 | + | |
| bridge_stp off # disable Spanning Tree Protocol | bridge_stp off # disable Spanning Tree Protocol | ||
| #bridge_fd 9 # forwarding delay # use default? | #bridge_fd 9 # forwarding delay # use default? | ||
| Line 66: | Line 66: | ||
| Each Ethernet hardware connection has its own defined unique MAC number, no need to define another. If Ethernet bonding were being used there maybe a need to use this stanza. | Each Ethernet hardware connection has its own defined unique MAC number, no need to define another. If Ethernet bonding were being used there maybe a need to use this stanza. | ||
| #hwaddress ether xx: | #hwaddress ether xx: | ||
| + | |||
| + | The " | ||
| + | |||
| + | The old fashion way was to manual assign as follows: | ||
| + | address 192.168.1.32 | ||
| + | network 192.168.1.0 | ||
| + | netmask 255.255.255.0 | ||
| + | broadcast 192.168.1.255 | ||
| + | Perhaps this is still required in special cases? | ||
| + | |||
| </ | </ | ||
| ++++ | ++++ | ||