Search

Fulltext results:

Router Miscellaneous

9 Hits, Last modified: 4 months ago

:61208'' and will autostart with ''sudo systemctl enable glances.service''. ---- ====ntopng==== I tried... ersion| <code>There seem to be 2 main services to enable/disable/start/stop, nprobe and ntopng: * ''sudo... 'sudo systemctl disable ntopng'' | to disable (or enable) starting on computer startup * ''sudo systemct... 'sudo systemctl disable nprobe'' | to disable (or enable) starting on computer startup We can also turn-o

Debian Server Network Setup

6 Hits, Last modified: 6 months ago

get </code> ++++ *The final command is used to enable the command to run at start-up: ''sudo systemctl enable ipv6_start.service''. *This also needs to be pe... on. ++++ ''vim torouter.sh'' | <code> #systemctl enable bind9 #systemctl enable isc-dhcp-server #systemctl enable nftables #systemctl enable pppoe #mv /etc/netpl

Wireguard VPN access from WAN to LAN

4 Hits, Last modified: 7 weeks ago

vice: ''sudo systemctl start wg-quick@wg0'' *To enable/disable the Wireguard service: ''sudo systemctl enable wg-quick@wg0'' *To check status of the Wireguard... rt number or range). The flags interval directive enables port ranges to be used. After that, you just set... rt number or range). The flags interval directive enables port ranges to be used. After that, you just set

NFTables Configuration

3 Hits, Last modified: 4 months ago

rt number or range). The flags interval directive enables port ranges to be used. After that, you just set... rt number or range). The flags interval directive enables port ranges to be used. After that, you just set... nf. Use ''sudo systemctl status/start/stop/reload/enable/disable nftables''. Start and reload basically r

DHCP / DNS Setup

2 Hits, Last modified: 7 months ago

[[https://unix.stackexchange.com/questions/756994/enable-tls-on-bind9|Enable TLS on BIND9]] *[[https://engineering.fb.com/2018/12/21/security/dns-over-tls/|DNS

ISP PPPoE Network Setup

2 Hits, Last modified: 10 months ago

ervice from activating at system startup. We will enable later, once configuration is more complete. To c... I managed to use so.</fs> =====System Forwarding Enable===== To allow the router to forward packet the L

Router Hardware

1 Hits, Last modified: 7 months ago

Intel integrated graphics device (IGD), which is enabled by default. The graphics then defaults to the BM

IPTables Configuration

1 Hits, Last modified: 7 months ago

A INPUT -m state --state ESTABLISHED -j ACCEPT # enable traceroute rejections to get sent out -A INPUT -p