Search

Fulltext results:

Router Miscellaneous

6 Hits, Last modified: 5 months ago

ersion| <code>There seem to be 2 main services to enable/disable/start/stop, nprobe and ntopng: * ''sudo... 'sudo systemctl disable ntopng'' | to disable (or enable) starting on computer startup * ''sudo systemct... 'sudo systemctl disable nprobe'' | to disable (or enable) starting on computer startup We can also turn-o... ''sudo systemctl disable redis'' | to disable (or enable) starting on computer startup </code> ++++ ----

Debian / Ubuntu Network Setup

6 Hits, Last modified: 10 months ago

get </code> ++++ *The final command is used to enable the command to run at start-up: ''sudo systemctl enable ipv6_start.service''. *This also needs to be pe... on. ++++ ''vim torouter.sh'' | <code> #systemctl enable bind9 #systemctl enable isc-dhcp-server #systemctl enable nftables #systemctl enable pppoe #mv /etc/netpl

ISP PPPoE Network Setup

2 Hits, Last modified: 12 months ago

ervice from activating at system startup. We will enable later, once configuration is more complete. To c... I managed to use so.</fs> =====System Forwarding Enable===== To allow the router to forward packet the L

IPTables Configuration

1 Hits, Last modified: 12 months ago

A INPUT -m state --state ESTABLISHED -j ACCEPT # enable traceroute rejections to get sent out -A INPUT -p

NFTables Configuration

1 Hits, Last modified: 6 months ago

nf. Use ''sudo systemctl status/start/stop/reload/enable/disable nftables''. Start and reload basically r