changes

Search

You can find the results of your search below.

Fulltext results:

VIM Editor
10 Hits, Last modified:
Vim Command ^ Action ^ | :w filename | Save changes to a file. If you don't specify a file name, Vim ... e name. | | :q | Quit Vim. If you have unsaved changes, Vim refuses to exit. | | :q! | Exit Vim without saving changes. | | :qa | quit all (close Vim, but not if there are unsaved changes) | | :qa! | quit all (close Vim without saving
Rsync
5 Hits, Last modified:
//Use with care!//** *''-n'' is for dry run, no changes are made, but proposed output is seen *''-P'' k... -%%dry-run'' |perform a trial run with no changes made| | | ''%%--%%delete'' |delete ... d to accept a new key or warned when the host key changes (like after a server upgrade, DHCP server has giv... wnHostsFile ~/.ssh/known_hosts</code> Make these changes active by restarting the ssh services via the com
Back-up Server Old Setup
2 Hits, Last modified:
ink_dest 0 # When sync_first is enabled, it changes the default behaviour of rsnapshot. # Normally, w... ink_dest 0 # When sync_first is enabled, it changes the default behaviour of rsnapshot. # Normally, w
NFS
2 Hits, Last modified:
ot need to be modified.// To apply configuration changes ''sudo systemctl restart nfs-server.service'' =... o install the nfs client To apply configuration changes ''sudo systemctl restart nfs-client.target'' The
Tripwire
2 Hits, Last modified:
== Trip wire check system files to check for any changes and alarms / alerts upon changes. ---- <- home_server:home_server_setup:other_services:monit|Prev ^ home
samba
1 Hits, Last modified:
an controls whether PAM will be used for password changes # when requested by an SMB client instead of the
snapraid
1 Hits, Last modified:
'sudo snapraid sync'' to sync the files that have changes since last sync. I usually do this weekly, manua
SSH Notes
1 Hits, Last modified:
change to the configuration file to activate the changes. *''sudo vim /etc/motd'' Displays the banner te