Search

You can find the results of your search below.

Fulltext results:

snapraid @home_server:home_server_setup:other_services
2 Hits, Last modified:
'sudo snapraid sync'' to sync the files that have changes since last sync. I usually do this weekly, manua... # SnapRAID is better suited for files that rarely changes! # Format: "data DISK_NAME DISK_MOUNT_POINT" data
KVM Setup
3 Hits, Last modified:
owed the VM NFS to work without any configuration changes, so remains working on both the new and old serve... - Create a snapshot of the VM and direct all changes to the snapshot allowing safe backup of main VM f... wing and editing files inside guests *scripting changes to VMs *monitoring disk used/free statistics
Rsync @home_server:home_server_setup:other_services
5 Hits, Last modified:
//Use with care!//** *''-n'' is for dry run, no changes are made, but proposed output is seen *''-P'' k... -%%dry-run'' |perform a trial run with no changes made| | | ''%%--%%delete'' |delete ... d to accept a new key or warned when the host key changes (like after a server upgrade, DHCP server has giv... wnHostsFile ~/.ssh/known_hosts</code> Make these changes active by restarting the ssh services via the com
SSH Notes @home_server:home_server_setup:other_services
1 Hits, Last modified:
change to the configuration file to activate the changes. *''sudo vim /etc/motd'' Displays the banner te
NFS @home_server:home_server_setup:other_services
2 Hits, Last modified:
''%%NEED_IDMAPD="yes"%%'' To apply configuration changes: ''sudo systemctl restart nfs-server.service'' '... o install the nfs client To apply configuration changes ''sudo systemctl restart nfs-client.target'' The
Network Setup
1 Hits, Last modified:
s: *''sudo netplan --debug apply'' To apply any changes to the network configuration. *''sudo netplan -
Back-up Server Old Setup @home_server:home_server_setup:other_services
2 Hits, Last modified:
ink_dest 0 # When sync_first is enabled, it changes the default behaviour of rsnapshot. # Normally, w... ink_dest 0 # When sync_first is enabled, it changes the default behaviour of rsnapshot. # Normally, w
VIM Editor @home_server:home_server_setup:other_services
10 Hits, Last modified:
Vim Command ^ Action ^ | :w filename | Save changes to a file. If you don't specify a file name, Vim ... e name. | | :q | Quit Vim. If you have unsaved changes, Vim refuses to exit. | | :q! | Exit Vim without saving changes. | | :qa | quit all (close Vim, but not if there are unsaved changes) | | :qa! | quit all (close Vim without saving
samba @home_server:home_server_setup:other_services
1 Hits, Last modified:
an controls whether PAM will be used for password changes # when requested by an SMB client instead of the
Tripwire @home_server:home_server_setup:other_services
2 Hits, Last modified:
== Trip wire check system files to check for any changes and alarms / alerts upon changes. ---- <- home_server:home_server_setup:other_services:monit|Prev ^ home