Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
linux_router:ubuntu [2025-05-17 Sat wk20 20:48] – [Debian Router Setup] baumkplinux_router:ubuntu [2025-05-22 Thu wk21 16:07] (current) – [Router Configuration & Server Setup] baumkp
Line 1: Line 1:
-{{tag>linux router "router configuration" setup debian ubuntu snap snaps}} +{{tag>linux router "router configuration" setup debian ubuntu snap snaps switch network}} 
-======Router Configuration & Server Setup======+======Router Configuration, Switch & Server Setup======
  
 =====Router Configuration===== =====Router Configuration=====
Line 52: Line 52:
  
 There are many ways to manually change the computer IP to facilitate this, and this depends upon the operating system and software used by that computer.  A key point is that the assigned manual address and address mask must place the manual assigned address in the same address range as the equipment to be configured.  It may not be the same address.  Say the equipment default assigned address is 192.168.56.34, then the computer must have an address assigned in the space 192.168.56.x/24 (or mask 255.255.255.0), where x is between 2 - 254, except in this case 34, which is the default assigned to the equipment to be configured.  There are many ways to manually change the computer IP to facilitate this, and this depends upon the operating system and software used by that computer.  A key point is that the assigned manual address and address mask must place the manual assigned address in the same address range as the equipment to be configured.  It may not be the same address.  Say the equipment default assigned address is 192.168.56.34, then the computer must have an address assigned in the space 192.168.56.x/24 (or mask 255.255.255.0), where x is between 2 - 254, except in this case 34, which is the default assigned to the equipment to be configured. 
 +  * ''ip a add 192.168.1.200/24 dev eth0''  to add an IP address to interface eth0
 +  * ''ip a del 192.168.1.200/24 dev eth0''  to add an IP address to interface eth0
  
 Once the computer network has been manually assigned and network reset check that the network address and mask have been correctly set.  If the assigned network mask is incorrect, that is in most cases not /24 (255.255.255.0), such as /32 (255.255.255.255) it is unlikely that the computer will be able to communicate to the equipment. In linux the following commands can be used to help: Once the computer network has been manually assigned and network reset check that the network address and mask have been correctly set.  If the assigned network mask is incorrect, that is in most cases not /24 (255.255.255.0), such as /32 (255.255.255.255) it is unlikely that the computer will be able to communicate to the equipment. In linux the following commands can be used to help: